This fluorescent plastic plate includes two UV LEDs to give your HK ship a glow. The plate assembles to the bottom of the ship. It becomes the structural component of the assembly, takes ball impact from below, and supports the ship when a ball hits from the top.
Lights are Red thrusters and UV to light the blue edge. Board includes a microcontroller to control light schemes.
Run the wires under the playfield and connect across a convenient GI bulb.
Assemble the locknuts to the existing screws, so that the plate sits level with the bottom of the molding. Leave the ship a little bit of slack. Then, tighten the washer locknuts hard against the wire and the plate.
The final assembly is much more rigid than the original. The plate is cut to precisely match the contours of the original Williams part.
Includes new screws, cable ties, locknuts and star nuts.
Install instructions at: http://mrtn.smugmug.com/gallery/8007494_n86Mz#532155709_Y3Twj