This IDC connector replaces burnt and damaged connectors in the WPC backbox. Used with our pusher tool, you can replace an entire connector is just a few minutes - even when working in the head. This connector is red, for 22GA wires. WPC systems only used 22GA 0.1" connectors.
This version has 10 pins. Cut it to the length needed. It is used for switch matrix and lamp matrix connections in the head, and some board connections underneath the playfield. The most commonly damaged connector is the connector for the trough boards. You can also use this connector to replace eddy sensor cable connectors, which often become weakened over time.
This is an END connector. The wires must end at the connector. If the connector that you are replacing has through wires, you will need to open the slots if you are to use this connector.
The connector is easily cut with sidecutters. Shave it with a razor for a neat finish.